Every day you go without a Vortex Valve™ is throwing money away.
Ford F150 4.6L 2006 Vortex Valve™ Installation
2006 FORD F150 WITH A 4.6L V8 POWER PLANT. THIS INSTALLATION TOOK ABOUT 60 SECONDS.
It's equally at home in bumper-to-bumper traffic on I 15 driving through Las Vegas at rush hour as it is driving to Los Angeles.
UNDER 5 MINUTE INSTALL ON A FORD F150 4.6L 2006
Increased Mileage
Big Power
Only $69.95
Plus S&H
Installing a Vortex Valve™ on your Ford F150 4.6L 2006 is as easy as 1,2,3.
Step 1
Make sure the engine is off. Always wear gloves when working on machinery that is not running. 
Loosen the clamp at the end of the air intake duct where it meets the throttle body like the picture.
Step 2
Remove the duct from the throttle body and insert a 43906 Vortex Valve™ in the duct with the flat side facing the throttle body. Push it inside the duct about ½ an inch.
Step 3
Replace the air intake duct over the throttle body and push it forward to its original position. Tighten the clamp. Done! You are ready for the open road or wall-to-wall traffic with plenty of power and response and great mileage too.
Guarantee
Your Vortex Valve(s)™ will be on its way to you within 7 working days. There are a few special applications and these may take a week or two longer. Your Vortex Valve™ is 100% guaranteed against any defects in workmanship and materials. Your Vortex Valve™ is made in the USA with high quality stainless steel that's made here too.
Air Synergy Labs, Inc offers a Lifetime replacement guarantee on workmanship and any manufacturer defects as long as you own the vehicle on which it is installed.
